What Is It?
Each block in the 10-pack measures 8.5 x 8.5 x 1.5 inches and interlocks with adjacent blocks to prevent slipping. Stacked in a ramp configuration, they can raise a tire 1.5 to 9 inches to compensate for site unevenness.
Rated to 40,000 lbs. Made from UV-resistant HDPE that handles Florida's sun without cracking.
How We Use It as RV Technicians
When we respond to a leveling system repair call, we often find the root issue is that the customer was trying to use their electric or hydraulic jacks to compensate for more than 6 to 8 inches of site unlevel - well beyond the designed range of most leveling systems. Pushing leveling systems past their range is a leading cause of motor burnout and cylinder failure.
The correct setup sequence - level side-to-side first using blocks under low-side tires, then deploy stabilizer jacks to take out any remaining front-to-back variation - is what we demonstrate on every leveling repair call. Camco leveling blocks are the tool that makes the first step achievable without a built-in automatic leveling system.
Why Every RV Owner in Winter Haven Should Have This
Florida campgrounds - particularly the lakeside and waterfront sites around Winter Haven's Chain of Lakes, Lake Kissimmee, and other Polk County sites - are often on land that was originally swampy or built up with fill. Significant site-to-site unevenness is common, and even the best automatic leveling systems have limits.
For anyone towing a travel trailer or fifth wheel, leveling blocks are not optional equipment - they are basic camping infrastructure. The 10-pack provides enough blocks to handle most site conditions.
Real Job Story from Winter Haven
We responded to a leveling system repair call at a Lake Wales campground where a couple's Lippert electric leveling system had stopped responding to the touchpad. The site they were parked on had approximately 8 inches of slope from driver side to passenger side.
Diagnosis: two of the four corner jacks had exceeded their maximum extension range trying to compensate for the unlevel site and the controller had entered a protection lockout state.
After resetting the controller and manually leveling the rig using the manual override procedure, we explained the proper setup sequence and demonstrated using their existing set of leveling blocks. They had the blocks on board but had not understood the sequence - blocks first, jacks second.
This was a no-charge educational service call. The couple understood the system correctly after the demonstration and have not had a leveling issue since.