How RV Awning Control Boards Work
Power awning control systems consist of a control board (also called a control module), one or two wall switches inside the coach, and in some systems an automatic retract wind sensor. The control board receives switch input from the wall switches, monitors the motor's current draw to detect travel limits (when the awning is fully extended or retracted, the motor's current increases as it reaches the end of travel), and may also integrate with the coach's automated systems on newer RVs.


When the control board fails, the awning typically loses all responsiveness - pressing the extend or retract button produces no motor activity. This can appear identical to a failed motor, which is why we verify power at the motor and check the control board status before replacing either component.
Carefree awning systems use specific control board part numbers that are not interchangeable with Dometic systems. We carry control boards for the most common models of both brands, but less common configurations may require a next-day part order to your Winter Haven location.
Common Control System Failures
Wall switch failure is the most common non-motor awning failure. The rocker switch inside the coach receives hundreds to thousands of actuation cycles over the awning's life, and the switch contact mechanism can fail to make reliable contact.
The switch may produce no response, intermittent response, or only respond when pressed in a specific way. Switch replacement is a simple and inexpensive repair.
Control board failure is less common than switch failure but produces more complete system non-response. The board may fail from moisture infiltration in the control board housing, power surge damage from poor campground pedestal wiring, or simple age-related electronic component failure.
Automatic retract sensor failure affects awning systems with wind-detection features (Carefree's Automatic Awning and similar systems). These sensors activate when they detect excessive wind-induced awning movement, automatically retracting the awning to protect it.
A failed sensor may either not retract when it should (leaving the awning vulnerable to wind damage) or retract constantly (retracting the awning whenever a light breeze touches it). Sensor replacement or adjustment resolves these issues.
Diagnosing Awning Control Issues
We begin awning control system diagnosis by verifying the motor is functional (connecting it directly to 12V power at the truck to verify rotation in both directions) before investigating the control system. Confirming motor health eliminates the most expensive component as the problem.
With motor function confirmed, we trace the control circuit: check the fuse (a blown awning fuse is common after a motor overload), check the wall switch for continuity in both positions, and then check for control board output signal when the switch is actuated. No signal from the control board despite good switch input and power supply identifies the control board as the failed component.
For automatic retract sensor issues, we observe the sensor's LED indicators (if present) during the test procedure to identify whether the sensor is triggering correctly or has failed in an active state.