How RV Water Heaters Work
Most RVs use a tank-style water heater with 6 or 10-gallon capacity that heats water on both LP propane and 120-volt AC electric. Dometic (which acquired Atwood) and Suburban are the two dominant manufacturers. These units heat water using a propane burner assembly for gas mode and an electric heating element immersed in the tank for electric mode.


The dual-mode design is an important feature for Florida camping. When parked on shore power, the electric mode heats water silently and efficiently without consuming propane.
When boondocking at state parks or dry camping sites, propane mode provides hot water without requiring shore power. Both modes can sometimes be operated simultaneously in larger units for faster recovery.
Tankless (on-demand) RV water heaters are gaining popularity as a more efficient alternative. These units heat water as it flows through a heat exchanger rather than maintaining a tank temperature.
Dometic's On-Demand and Precision Temp's series are the most common RV tankless units. These have different failure modes from tank units and require different diagnosis approaches.
Common RV Water Heater Failures in Winter Haven
The most common water heater call in Winter Haven is no hot water on electric mode with propane mode working normally. This specific pattern (one mode works, the other doesn't) immediately narrows the diagnosis.
When propane works but electric doesn't: the heating element or its circuit (element, thermostat, or 120V wiring) has failed. The element is the most common cause - a standard wear item that should be replaced every 5 to 7 years under Florida's year-round operation. We test the element resistance with a meter (an open circuit reading indicates failure) and replace it on-site.
When electric works but propane doesn't: the propane supply circuit (gas valve, pilot assembly, or igniter) has failed. We check the gas supply, test the 12V ignition circuit, and inspect the burner assembly for debris or thermocouple failure.
When neither mode works: check the thermostat first. A tripped high-limit thermostat (a safety device that cuts power to both heating modes when water temperature exceeds the safe limit) can disable both modes simultaneously. It resets by pressing the red button on the thermostat housing inside the service compartment.
Rusty or metallic-tasting hot water indicates a depleted anode rod that has allowed tank corrosion to begin. Replace the anode rod immediately and flush the tank to remove rust particles before the corrosion penetrates the tank wall.
Water Heater Element Replacement in the Field
Heating element replacement is the most common water heater repair we perform on service calls in Winter Haven. The procedure requires turning off the 120V circuit breaker for the water heater, shutting off cold water supply, opening a hot water tap to relieve pressure, and draining the tank through the drain plug or anode rod port.
The element threads into the tank wall at the bottom of the tank and can be removed with the correct element wrench. We carry 120V/1440W elements compatible with all common Atwood and Dometic 6-gallon and 10-gallon units. The replacement element is installed with plumber's tape on the threads, the tank is refilled, power is restored, and the element is tested by verifying the correct amperage draw.
We always replace the anode rod simultaneously with element replacement - if the tank has been in service long enough for the element to fail, the anode rod is likely near depletion. The combined cost of element plus anode replacement is less than a future service call for the anode alone.