RV Gas Stove and Oven Systems
RV gas ranges and stoves use LP propane as their fuel source, connected to the coach's propane system through an internal regulator or directly from the main propane regulator. The burner design is simpler than residential gas ranges - smaller burners with lower BTU output appropriate for RV ventilation requirements, and typically an electronic igniter system that creates a spark at each burner tip when the knob is turned.


The specific failure modes for RV gas cooking appliances center on the ignition system, the burner assembly, and the gas supply circuit. In Florida's humid coastal environment, the electronic igniter's spark electrode and igniter tip can corrode and fail to produce a reliable spark.
The burner ports that direct gas to the flame can become blocked with cooking residue or insect nesting material during storage. The gas valve or orifice can develop deposits that restrict flow and produce a weak, yellow flame rather than the clean blue flame of properly burning LP.
Common RV Stove Failures
Igniter clicks but no flame: the spark is present but the gas is not reaching the burner. Check that the propane supply is on (main valve at the tank and any interior shutoffs).
If propane is confirmed on, the burner orifice or gas valve may be restricted. A burner that lights with a match but won't self-ignite has an igniter issue - the spark electrode may be corroded or misaligned.
Weak yellow flame instead of strong blue: LP gas burns cleanly with a blue flame when the air-gas mixture is correct. A yellow, flickering, or low flame indicates either low propane supply pressure (tank nearly empty or regulator failing), a partially blocked orifice, or improper air-gas mixture from a damaged or clogged burner assembly.
Igniter sparks continuously: the burner port area is wet from spillover, causing the spark to not extinguish properly. Clean the burner area and allow to dry completely. If sparking continues after drying, the ignition module may be failed and require replacement.
Oven doesn't hold temperature: the oven thermostat has drifted out of calibration (common after years of use) or has failed. We test oven temperature against a calibrated probe at multiple setpoints to determine if the thermostat is within acceptable tolerance or requires replacement.
Stove Repair at Your Winter Haven Location
Most RV stove repairs are completed right where your RV is parked. Igniter replacement, burner cleaning, and orifice clearing are all on-site procedures. We clean all burner ports with compressed air and a soft brush, remove any nesting material (insects frequently nest in stove burners during storage), replace corroded igniter electrodes, and test all burners through multiple ignition cycles before leaving.
For gas valve or regulator issues, we test the propane supply pressure at the appliance with our manometer. Correct LP pressure at the appliance inlet is 11 inches water column. Low pressure indicates a regulator issue or low tank pressure; high pressure indicates a regulator failure in the over-pressure direction, which is a safety issue requiring immediate attention.